Issue: #3 (36)
Table of ContentsProduction Process Procedures and Machines
Corrosion-fatigue endurance of welded joints of low-carbon steel after laser and plasma treatment of surface
| Authors: Safonov A.N., Bakaeva R.D. | |
| Keywords: | |
Design method for hot-rolling mill roll profiles. Part 1. Theoretical grounds of the method
| Authors: Borisov V.I., Varikov V.A. | |
| Keywords: | |
Induction-metallurgic method for hardening the large surfaces
| Authors: Zaichenko Yu.A., Kazennov N.P., Kazintsev N.V., Kosarevsky V.V., Khoruzhy G.A. | |
| Keywords: | |
Production of silicon for solar battery by two-stage carbo-thermal method
| Authors: Abdiukhanov I.М., Bogachev Е.А., Ivanov Yu.A. | |
| Keywords: | |
Simulation of Processes
Wind gas turbine units with pneumatic transmission for electrogenerator drive
| Authors: Yanson R.A. | |
Category: Simulation of Processes |
|
| Keywords: | |
End phenomena at axial compressor designing
| Authors: Beknev V.S., Tumashev R.Z. | |
Category: Simulation of Processes |
|
| Keywords: | |
Influence of helium thermal properties on parameters of gas turbine plant items
| Authors: Ivanov V.L., Surovtsev I.G., Beknev V.S. | |
Category: Simulation of Processes |
|
| Keywords: | |
Dynamic algorithms to control programmed turn of spacecraft
| Authors: Levsky M.V. | |
Category: Simulation of Processes |
|
| Keywords: | |
Dependence of maximum rest frictional force on roughness
| Authors: Nikolaev D.A. | |
Category: Simulation of Processes |
|
| Keywords: | |
Fundamental Problems of Mechanical Engineering
Software for hydrodynamics, gas dynamics, heat and mass transfer analysis
| Authors: Glebov S.F., Makarov D.V., Skibin A.P., Yugov V.P. | |
| Keywords: | |
Dynamics, Strength, Reliability
Analysis of creep buckling of rectangular plate
| Authors: Romanov K.I. | |
Category: Dynamics, Strength, Reliability |
|
| Keywords: | |